Support

Technical Information

Copper Press Product Range

Flowflex reserve the right to alter the product ranges and specifications associated with its products without prior notice

General Specification

This general specification provides an overview of the key features and capabilities of the product range. However, it is important to review the specific technical details and credentials of each individual product before use, as these may vary. Always verify that the product meets your specific requirements and standards for your intended application.

Products

This technical data sheet outlines the general specifications for the products listed below. Please be aware that specific details may vary between products. For precise information tailored to each product, please consult the relevant product page on our website.

Product Codes

6040M, 6041M, 6090GM, 6090M, 6092GM, 6092M, 6130GM, 6130M, 6130RM, 6240GM, 6240M, 6243GM, 6243M, 6270GM, 6270M, 6270SM, 6301M, 6341GM, 6472GM

Approvals

Flowflex holds ISO certifications independently audited by the British Standards Institute, ensuring credibility and trust with consumers, clients, and business partners alike. We take pride in these certifications and are committed to continuous improvement to better serve our clients.

BSI ISO:9001, ISO:14001 Approval Mark

Standards

The products in this range are manufactured in accordance with the following standards to ensure superior quality, safety, performance, and compatibility:

Assembly

How To Install M Profile Press Fittings

Equipment

Tools
  • Press Tooling - 'M' Profile Jaws
  • Press Gun
Supplies
  • Pipe
  • M Profile Press Fittings

Installation Steps

Check And Mark
Image showing an installer marking his pipe to cut accurately to size

Before inserting the pipe, check the O-ring is present, lubricated and free from damage.

Insert the tube into the fitting up until it hits the pipe stop. Mark the insertion depth with a black marker on the tube to ensure the pipe has been fully inserted before pressing.

Make Sure Everything Is Clean and Free of Debris

It is important that the outside of the pipe and the socket of the fitting are clean and free from debris. Any debris could damage the O-Ring on insertion.

Crimp The Fitting
Image showing an installer crimping the M Press profile Copper Fitting

Ensure you select the correct size jaw and that the jaw is M profile. The jaw must be placed square on the fitting and the joint is only complete when the mouth of the fitting is fully enclosed by the jaws.

After the press cycle is complete remove the jaws and check that the socket depth marking on the pipe has remained in place, adjacent to the now pressed mouth of the fitting.

Any Questions?

Our team is available for you anytime.